Re: temp gauge
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: temp gauge



Upon reviewing the wiring diagram and the manual if the voltmeter is 
working the most likely problem is either a broken or disconnected 
wire to the sending unit. It is located under the intake manifold on 
the water distribution pipe. See parts manual 2-3-0 and 1-3-0. It is 
hard to reach, the easiest way is to remove the intake manifold. It is 
also possible for the sending unit to be bad, to test just momenteraly 
ground the wire, you should see the gauge move.
David Teitelbaum
vin 10757



> 
> 
> --- In dmcnews@xxxx, Soma576@xxxx wrote:
> > 
> > [Non-text portions of this message have been removed]






Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated