Jim, I some posted door lock troubleshooting info a couple of months ago... http://www.egroups.com/message/dmcnews/8261?&start=8236 Basically, you need to determine if the problem is with the wiring through the doors, the solenoids/switches, or the lock module. There's about a 90% probability that it's the module. Good luck, Gus Schlachter Austin, TX VIN# 4695 > -----Original Message----- > From: Jim Reeve [mailto:ultra@xxxx] > Sent: Sunday, August 27, 2000 3:45 PM > Subject: [DML] Power Lock Harness > > > Does anybody have a diagram for the electrical harness for the door > locks? My control unit will lock both doors, but will not unlock > either. I know this is most likely the control unit itself, but I would > like to test the solenoids without taking the doors apart, so I need to > know which wires to jump on the connector from the control unit. > Thanks. > -- > Jim Reeve <Ultra>