RE: [DML] Angle drive lubrication
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [DML] Angle drive lubrication



During my 3.5 years of ownership and 20k miles, I've only checked this
twice. Once when I bought it and once about two years ago. When I did this
last, I threw in some leftover synthetic gear oil from the supply that I put
in the transmission (Redline MTF). I haven't seen any problems so far! I'm
pretty confident in the lubrication - maybe I'll get around to checking it
whenever I pull the wheel off next...

Travis Graham
#6344


-----Original Message-----
From: Mark Noeltner [mailto:mark@xxxx]
Sent: Wednesday, August 16, 2000 9:38 PM
To: dmcnews@xxxxxxxxxxx
Subject: [DML] Angle drive lubrication

What's the best way to lube the angle drive? I've been following the
original factory service bulletin and filling it with 90w gear oil at each
oil change. It's been fine so far, but I would like to hear opinions on
other methods. Would greasing it with a grease gun be better? Or would that
be too thick and cause extra resistance?






Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated