Cliff, its a long slow job re-filling the system..there is something currently running on the same subject on the DML..basically you have an air lock, keep filling up the bottle and loosening off various hoses until you have it as full as you can. run for a few minutes, let stand till cool, re-fill etc..you will get there eventually! Chris P Derby 95 ----- Original Message ----- From: "Cliff Andrews" <fen2k@xxxx> To: <dmcnews@xxxxxxxxxxx> Sent: Tuesday, July 04, 2000 10:55 PM Subject: [DML] cooling problem! > hi everyone.. today i replace 3 of my coolent hoses > around the engine. I replaced the hose going to the > coolent bottle, the hose going into the water pump and > the hose going out of the pump. Now when i took off > the old ones coolent came rushing out. I assume it was > not all of it. I put the hoses back on and filled the > coolent bottle to the max line, the coolent bottle > didnt drain into the hoses very much it just filled > the bottle and sat. I turned on the car and let it > run for a while.. my temperature started to raise and > no fans kicking on, also the level in the bottle did > not lower. So if i let it run it would eventually > overheat. What am i doing wrong? Helpppp! > > -Cliff Andrews > > __________________________________________________ > Do You Yahoo!? > Kick off your party with Yahoo! Invites. > http://invites.yahoo.com/ > > > > > Before posting messages or replies, see the posting policy rules at: > www.dmcnews.com/Admin/rules.html > > To address comments privately to the moderating team, please address: > moderator@xxxx >