Jonathan, I recently completely restored the front end of my car. I was able to find every single nut and bolt at my local Eagle Hardware. I don't know if you have one of these where you are, but chances are, you should be able to find most of the nuts and bolts at a local hardware store. I took most of the old nuts and bolts to the store with me to measure the size, thread, etc., but most of that information is in the tech manual. I know that there is a software version of the tech manual if you don't have one. I may be able to tell you the size etc. of possibly any bolt if you want to shoot me some e-mail. Good luck! Dave -----Original Message----- From: Jonathan Miller [mailto:betaray@xxxx] Sent: Thursday, February 17, 2000 8:24 AM To: dmcnews@xxxxxxxxxxx Subject: [DML] Hardware (was: Facia Removal) I'd like to thank everyone who helped me out with my problem. I finally was able to get what I was seeing to correspond with what I was reading, and get the thing removed. I've noticed that alot of my hardware is completely rusted out. Does any know if one of our fine parts dealers sells stainless nuts, bolts, etc? Or possible has a conversion table so that I can find out my own hardware. E.g. M6 = x size, x length, etc. Thanks, Jonathan ------------------------------------------------------------------------ Before posting messages or replies, see the posting policy rules at: www.dmcnews.com/Admin/rules.html To address comments privately to the moderating team, please address: moderator@xxxx ------------------------------------------------------------------------ eGroups.com Home: http://www.egroups.com/group/dmcnews/ http://www.egroups.com - Simplifying group communications