[DML] Re: Angle drive problems again!!??!!
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[DML] Re: Angle drive problems again!!??!!



I know the speedo cable isn't bad.  I know that the speedometer is turning from the cable.  I know that the angle drive works (until you hook up the speedo cable)  I know that the plastic cap is attached firmly to the spindle.  Could someone pleasetell me what I'm missing?  Any help would be greatly appreciated! 
 
Duke,
 
You have a lower cable running from the angle drive to the lamba counter. Then another cable goes from it to the speedometer. If they'r attached properly and not broken and the angle drive is working properly,that is both the lower speedometer cable and the short cable running through the spindle to the pastic cap are in tact and turning free, then the problem must be related to the plastic cap. Sometimes adding a bit of foam tape to the outside of the plastic cap will assure proper contact between the cap andthe front wheel to assure nothing is slipping. The square hole in the cap must be square and not rounded out. It's all physics, if everything is connected and not broke, it has to work!
 
Bruce Benson
 
 
 
 
 
 

click here
Click Here!

eGroups.com home: http://www.egroups.com/group/dmcnews
www.egroups.com - Simplifying group communications


To address comments privately to the moderating team, please address to moderato-@xxxx, not to the eGroups address shown


Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated