I recently purchased a set of new inner door seals from PJ Grady, and after spending an hour putting them on, I couldn't get the doors to close properly. First, they wouldn't even close half-way, and after readjusting them a bit, the doors would close fully, but only after applying massive amounts of force. I let them sit for awhile, hoping that they just needed to settle in, but that didn't work. I called Gradys, and they said that they have a procedure for grinding down the edge that the seal mounts onto, but I would have to talk to Rob about it. I've called back a few times but Rob has been to busy to explain the procedure. So... could anybody else shed a little insight into this procedure? Or are there any other hints for getting this to work? TIA, Luke ------------------------------------------------------------------------ eGroups.com home: http://www.egroups.com/group/dmcnews http://www.egroups.com - Simplifying group communications