It is very likely that the anchor pins that the door locks close on were adjusted to the old, worn door seals. With the new seals the pins must be readjusted. It is not too hard to do but if you don't have a lot of experience it could take a while of trial-and-error. Take the round rubber grommets off and you will see that you can put a wrench on the pin to loosen it so you can reposition it. The pin should go right into the center of the door lock without banging on the guides. Both pins must hit the first locking position at the same time. Remember that the door closes in an arc. For the first time you try this you will find it easier if you remove one of the pins and adjust the other pin first and then reinstall the one you removed and adjust it to the first one. In some cases you must file away some of the fiberglass to get a little more adjustment room for the pin. David Teitelbaum vin 10757 --- In dmcnews@xxxxxxxxxxxxxxx, "zeilner0" <zeilner0@xxxx> wrote: > > > I tried to mount the inner seal on my passenger door. But after > mounting, the door won´t close any more. I couldn´t find an other way > of mounting. Is there a trick, or can I get a seal that fits? Please > help a new delorean owner in Austria > > Gerhard To address comments privately to the moderating team, please address: moderators@xxxxxxxxxxx For more info on the list, tech articles, cars for sale see www.dmcnews.com To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/dmcnews/ <*> To unsubscribe from this group, send an email to: dmcnews-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/