[doc] Re: Removing the CAT
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[doc] Re: Removing the CAT
- From: "blackaddertoo" <blackaddertoo@xxxxxxxxxxx>
- Date: Mon, 13 Feb 2006 23:28:42 -0000
Hi Paul
As far as i am aware, any original trailing arm bolts should be
replaced by the modern stronger replacement.
i will do mine as soon as i have the MOT.
i think removal of the CAT in theory should give a power increase,
however i seem to recall an article in the DOC mag where a car was
tested before/after and not really that much difference found.
Regards
Steve
--- In doc-uk@xxxxxxxxxxxxxxx, "Paul" <willinot@...> wrote:
>
> When Im doing some work on Vin 2493 I have been thinking of
removing
> the CAT.
>
> Is this just a bolt off, bolt on job or is there much more too
it.
> Are there any reasons why I should not remove it. And finally are
> there any advantages (bar the power increase) for removing it.
>
> I had heard its better for the engine without it (main reason for
> removing) but wanted to confirm this.
>
> Cheers
>
> Paul 162
> Belfast
> 2493
>
> ps:
>
> also posted some photos of the trailing arm bolts as removed over
> the weekend. Can anyone confirm if these are non-orignals (as I
> have never seen a set before). They came out fairly easy although
I
> have noticed that the drivers side one is very slightly bend (you
> can only notice it by looking down the length of the bolt). Im
> assuming that if they are bent at all they should be replaced or
am
> i wrong in thinking that.
>
DOC UK Website: www.deloreans.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine **
SPONSORED LINKS
YAHOO! GROUPS LINKS
Back to the Home of PROJECT VIXEN