Re: [doc] finally driven her!!
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [doc] finally driven her!!



thanks Richard, i'll try it with the T panel. Already took out
screws and bent back tangs at top of rear window. just the seal glue
holding it.

and i will try the oxygen sensor, what should it do if unplugged?

regards

Steve





--- In doc-uk@xxxxxxxxxxxxxxx, "Richard" <dickyh11@xxxx> wrote:
> Hi Steve,
>
> Nice one! Great feeling isn't it?
>
> Assuming the wandering revs are at idle, this could be due to a
duff
> oxygen sensor, unplug it (behind the drivers seat, it comes
through a
> rubber bung in the bulkhead) and see what happens.
>
> T panel clearances 'should be' whatever you need to make them so it
> works :)
> Normally lifting the t section (skywards) fixes catching doors.
Bung
> some bits of cardboard box under it to see if it makes a
difference,
> then do a proper job with some foam pads. Difficult to advise
without
> seeing it of course...
>
> Rich H
> DOC 365 VIN 1274
>
> > -----Original Message-----
> > From: doc-uk@xxxxxxxxxxxxxxx [mailto:doc-uk@xxxxxxxxxxxxxxx] On
Behalf
> Of
> > blackaddertoo
> > Sent: 31 July 2005 00:51
> > To: doc-uk@xxxxxxxxxxxxxxx
> > Subject: [doc] finally driven her!!
> >
> > Hi all
> >
> > actually finally driven my car after a nearly a year, although
only
> > a few yards up and down the drive!!.
> >
> > first time its move under its own power for 12 or so years!.
> >
> > a few questions if anyone can help.
> >
> > first the T roof panel, it does now catch after new door
> > struts..i've loosened it but it will only really move up (not
back)
> > what should the clearance at the corner of the door be? ie how
far
> > up should it move?.
> >
> > and the engine...it will run but tends to wonder through the rev
> > range, almost stalling, battery is now low and car is an early
vin
> > for older alternator. i have not yet replaced injectors, plugs
etc.
> > any ideas before i take the manifold off?
> >
> > just want to get it through its MOT first.
> >
> > jobs done so far... new tank, filter, pipes, pump, baffle, recon
> > calipers, new discs+pads, front bearings, all struts, brake
pipes,
> > battery, clutch master, clutch slave.
> > if anyone needs tips on these just email.
> >
> > tahnx all
> >
> > regards
> >
> > steve
> > vin1621
> > doc 370
> >
> >
> >
>
>
>
>      
>      
>            
> ___________________________________________________________
> Yahoo! Messenger - NEW crystal clear PC to PC calling worldwide
with voicemail http://uk.messenger.yahoo.com





DOC UK Website: www.deloreans.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine **




YAHOO! GROUPS LINKS






Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated