[doc] Re: Replacing rear speakers
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[doc] Re: Replacing rear speakers
- From: "Chris Williams" <chris@xxxxxxxxxxxxxxxxxxxxxxx>
- Date: Thu, 28 Apr 2005 09:04:10 -0000
Thanks for the reply's so far. Just to add I the same as Phil am
using the pyramid 4108gs speakers, they do seem to be a good
quality. I also purchased pyramid 328gs speakers for the front.
However these may be a problem because of a pronounced 'tweeter'
however I willnot know until I relace the dash and binacle later in
the year. What is required is some thread extenders I think, anyone
know where to get such a thing? I have also replaced the speaker
wiring.
Shannon, I would very much appreciate it if you would be good enough
to e mail me the copies of the fitting instructions that you have,
pdf please. And Phil thanks for the offer I may have to take you up
on it! If any one knows of where to get thread extenders from could
they please post that also.
Thanks everyone
Chris
#4584
--- In doc-uk@xxxxxxxxxxxxxxx, "nick12dmc" <Tammyfew@xxxx> wrote:
> Hi Phill,
> I fitted some Pyramid's to my D' also. The front
speakers
> I got from Halfords. With a JVC 45W X4 cd unit it is a massive
> improvement.
>
> Regards
> Nick H
> --- In doc-uk@xxxxxxxxxxxxxxx, "Phill Wright" <psw@xxxx> wrote:
> >
> > Hi Dan,
> >
> > I used Pyramid 4108GS 300W 3-way units (they are 4 ohm, no 8 as
the
> > originals, they are on offer here - only £23.95 pair - free UK
> > delivery!
> > http://tinyurl.com/9sxud
> > Now, they are 4 x 10 but the magnet is 1/2 inch bigger than the
> Craig
> > jobbies - but if you take the speaker mount brackets out of the
> car,
> > flatten the 3 locating tabs and rebend them wider they will fit
> fine -
> > you also need 2 new 4" jubilee clips as the original ones are
too
> > small. Also (minor point) on the original Craigs, the -ve
> connection
> > on the spkr is a thin one, the +ve a normal size one, the new
spkrs
> > both have standard size push connector terminals - I just
snapped
> the
> > thin terminals off the old scrap spkrs and soldered em onto the
new
> > spkr -ve terminal so the original wiring didn't need altering.
> > The new spkrs are gold mylar cones with twin units centre
mounted -
> > 300W claim is probably more 'Clive Sinclair' power rating rather
> than
> > RMS or Peak, but they are certainly well beefier than the
> originals.
> > I only have the original Craig radio at the moment as my DAB
unit
> > hasn't landed yet, so have yet to give em a good blast of
power :-)
> >
> > Cheers
> >
> > Phill W
> > DOC 233
> > VIN 6772(sorbet)
> > Avantime (M4TRA)
> >
> > --- In doc-uk@xxxxxxxxxxxxxxx, Daniel Shane <daniel.shane@xxxx>
> wrote:
> > > Hi Phill,
> > >
> > > What speakers did you fit and where did you get them from ?
> > >
> > > Cheers
> > >
> > > Dan
> > >
> > >
> > > On 27/4/05 11:24 am, "Phill Wright" <psw@xxxx> wrote:
> > >
> > > >
> > > > Hiya,
> > > >
> > > > I've just done mine - wasn't half as bad as I thought! I can
> email
> > > > you my phone number if you want to have a chat about it ...
> > > >
> > > > Phill W
> > > > DOC 233
> > > > VIN 6772(sorbet)
> > > > Avantime(M4TRA)
> > > >
> > > >
> > > > --- In doc-uk@xxxxxxxxxxxxxxx, "Chris Williams" <chris@xxxx>
> > wrote:
> > > >> >
> > > >> > I have been searching thru the archives over the last day
or
> > so of
> > > > all
> > > >> > the different delorean web sites, looking for an artical
with
> > > >> > diagrams/and or pictures for the repalcing of the rear
> > speakers. I
> > > >> > know that I have seen this once before somewhere but
cannot
> > find it
> > > >> > again. If any one knows where this artical is and can e
mail
> > me the
> > > >> > link or indeed tell me the easiest way to replace the
rear
> > speakers
> > > > it
> > > >> > would be appreciated.
> > > >> > Thanks all,
> > > >> > Chris
> > > >> > vin #4584
> > > >
> > > >
> > > >
> > > >
> > > >
> > > > DOC UK Website: www.deloreans.co.uk
> > > > Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
> > > > ** Unless otherwise stated, all messages posted to the group
> are
> > assumed
> > > > public and may be printed in the club magazine **
> > > >
> > > >
> > > >
> > > > Yahoo! Groups Links
> > > > * To visit your group on the web, go to:
> > > > * http://groups.yahoo.com/group/doc-uk/
> > > > *
> > > > * To unsubscribe from this group, send an email to:
> > > > * doc-uk-unsubscribe@xxxxxxxxxxxxxxx
> > > > <mailto:doc-uk-unsubscribe@xxxxxxxxxxxxxxx?
subject=Unsubscribe>
> > > > *
> > > > * Your use of Yahoo! Groups is subject to the Yahoo! Terms
of
> > Service
> > > > <http://docs.yahoo.com/info/terms/> .
> > > >
> > >
> > >
> > >
> > >
> > > [Non-text portions of this message have been removed]
DOC UK Website: www.deloreans.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine **
Yahoo! Groups Links
Back to the Home of PROJECT VIXEN