Re: [doc] re rear hub removal...help!!!
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [doc] re rear hub removal...help!!!
- From: "blackaddertoo" <blackaddertoo@xxxxxxxxxxx>
- Date: Wed, 20 Apr 2005 08:10:26 -0000
--- In doc-uk@xxxxxxxxxxxxxxx, Martin Gutkowski <martin@xxxx> wrote:
> blackaddertoo wrote:
>
> >hi again
thankyou for the help.
yes i'm trying to change the discs and rebuild calipers.
i must admit i have not seen a screw, does this just hold the disc
onto the hub? and is it at the front or back?
i spotted last night that there are access holes for a socket for
the calipers, (although drive shaft is a bit in the way for one of
them. have got one two move with my extending socket set.
i'll take a look later as i would like to do this without touching
the hub nut (270!!!!)
i thought the set up might be like the front ie remove hub to change
the discs.
thanx again for any help
a bit frustrating as i have never driven her (after about 6 months!)
regards
Steve
> > Hi All
> >
> > my rebuild of vin 1621 is going ok (but slow) but i've come to
the
> > rear brakes.
> >
> > Does anyone know if it is ok to put into gear (manual) to stop
rear
> > wheel and hub nut turning.
>
> STOP! You don't need to remove the hub to take the disc off (I
assume
> that's what you're doing). Just undo that piddly screw with an
impact
> driver and tap it off.
>
> >
> >
> > Also are there any tips on removing the rear calipers.
>
> 16mm spanner, ring end and a hammer to get it started, than a 16mm
> socket on a 3/8 extension, there is a n access hole in from the
other
> side on the top one.
>
> Martin
DOC UK Website: www.deloreans.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine **
Yahoo! Groups Links
Back to the Home of PROJECT VIXEN