Re: [doc] Procedure for replacing valve cover gaskets
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [doc] Procedure for replacing valve cover gaskets



Just undo all the bolts, and lift off..... they aren't adhesive gaskets
like head gaskets and will just peel off. Just torque the bolts down
nice and tight. I tend to use my 1/4" drive for this job as it's not
really possible to over-torque the bolts with it

Martin

Stian Birkeland wrote:

>
> What's the correct procedure when replacing the valve cover gaskets?
>
> Surface must be clean, yes? Get rid of all the remains of the old
> gaskets. Tips???
>
> Do you apply any "stuff" to the new gaskets before putting them on?
> If so what? and do you apply the "stuff" to both sides of the gaskets?
>
> And tightening specs for the valve cover bolts are?
>
> A detailed description from you any of you guys would be nice.
>
> Best wishes
> Stian Birkeland
> Norway
>
> VIN # 06759




DOC UK Website: www.deloreans.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine **




Yahoo! Groups Links



Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated