Paul, If its the similar nut to the one that holds the speedo on the other side, I tried all sorts but could not find anything strong enough. I ended up at my local scrap yard ( not car breakers) and bought a very old, heavy open ended spanner ( for ?2) that was just a little too small, a quick "dress up" with my angle grinder and it did the job real good. Even then, I used the spanner in a "pointing down" position, and belted it on top, with a bloody big hammer, it came undone straight away. Prior to that I had "jacked the car up" under the end of the spanner, but it would not give "going up". Hope this helps..if any one wants to borrow my spanner feel free, but it would cost about ?10 to post it! All the best, Arkwright......BTW, when I was on my cruise, 3 different people thought I looked and sounded like that fat old fart, Ronnie Barker! Can you believe that! Amazing! -----Original Message----- From: Paul Salsbury [mailto:paul.salsbury@xxxx] Sent: 30 April 2002 08:27 To: doc-uk@xxxxxxxxxxxxxxx; dmcnews@xxxxxxxxxxxxxxx Subject: [doc] What size I need to remove my NUT,STUB AXLE.INNER.RH part no 108514 to change my front discs, however I will have to go and buy a socket as I don't have one large enough. What size is it? it looks around a 32mm. Cheers Paul #6463 www.paul.salsbury.btinternet.co.uk DOC UK Website: www.delorean.co.uk Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx ** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine ** Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/