Niether does mine, front of back... Martin did you get the door lock module yet???? Paul #6463 ----- Original Message ----- From: "Martin Gutkowski" <webmaster@xxxx> To: <doc-uk@xxxxxxxxxxxxxxx> Sent: Thursday, December 13, 2001 12:23 PM Subject: Re: [doc] Hood (or bonnet) 'popping' up when released > Is the same true for the engine cover? Mine doesn't "pung" either... > > Thanks > > James > > James Espey wrote: > > > Early cars were fitted with a spring that didn't properly release the hood - > > this was the subject of an unpublished, and therefore, relatively unknown > > service bulletin. A new spring (Part #110279) was issued and fitted on most > > of the later cars. It can be easily fitted to any car. Available from any of > > the vendors for less than $3, I believe. > > > > James Espey > > DeLorean Motor Company > > Houston, Texas > > > > 281/568-9573 > > 800/USA-DMC1 > > http://www.delorean.com > > > > > From: Martin Gutkowski <webmaster@xxxx> > > > Reply-To: doc-uk@xxxxxxxxxxxxxxx > > > Date: Thu, 13 Dec 2001 00:07:26 +0000 > > > To: doc-uk@xxxxxxxxxxxxxxx > > > Subject: Re: [doc] High Hood > > > > > > Does yours pop up properly when you pull the lever? Mine doesn't and I > > > reckon compressing the seals a bit moreby dropping the latch might help. > > > > > > Martin > > > #1458 > > > > > > > > > DOC UK Website: www.delorean.co.uk > > Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxx > > ** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine ** > > > > Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ > > > > DOC UK Website: www.delorean.co.uk > Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxx > ** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine ** > > Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ > >