Fw: [DML]Front section Frame PICTURE
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Fw: [DML]Front section Frame PICTURE



Keep a good eye under your cars!!! It starts me thinking again about
Stainless Steel or Hot dipped galvanising.


Chris P

----- Original Message -----
From: <jus4sho@xxxx>
To: <dmcnews@xxxxxxxxxxxxxxx>
Sent: Friday, February 16, 2001 3:03 AM
Subject: Re: [DML]Front section Frame PICTURE


> David, it looks like you ran into about the same thing I did on 02650. I
had
> to drill out the spot welds to remove the rotted section. I'm going to
clean
> the inside of the frame and recoat it before I weld in a new piece of
sheet
> metal. FYI, the bad corrosion in that area is the result of a combination
of
> things: 1) As you mentioned, there's no drain hole and 2) The epoxy barely
> made it into this section, leaving about half the metal inside this area
> completely bare. (Once I removed the lower plate, I could see how the
epoxy
> must have came in the little hole at the top, and barely made it halfway
down
> the sides before tapering to a paper-thin edge.)
>
> You can see the shots of the frame cut open on my site:
> http://www.angelfire.com/md2/projectdelorean/fr0101.html
>
> Steve
> VIN 2650 ("Project Delorean")
>
>
> Before posting messages or replies, see the posting policy rules at:
> www.dmcnews.com/Admin/rules.html
>
> To address comments privately to the moderating team, please address:
> moderator@xxxx
>





Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated