[doc] Info for Rich H
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[doc] Info for Rich H




Hi Rich,
        Nice to see you at the NEC. Here is the info. on the Flywheel
holding tool. Check out www.Lasertools.co.uk. Part No.3203.
Put a bolt through the slot into the lower mounting hole for
the starter motor and put a nut on the other side, adjust the teeth
so they mesh with the flywheel. The engine is then locked. and the
pulley nut should be a lot easier to get off.
Cost about £7. Propane torch I used burns MAPP gas. This burns
extra hot and was better than my little propane blowlamp.
All the best
Nick H





DOC UK Website: www.deloreans.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine **



Yahoo! Groups Sponsor
ADVERTISEMENT
click here


Yahoo! Groups Links



Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated