[doc] Pulley Nut Is Off!
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[doc] Pulley Nut Is Off!



Hi All,
Have at last managed to remove the Pulley nut. YES!
A few things I have learned from my fight.

1. Buy a Flywheel Holding Tool. The Laser hand tools
model 3203 £6.99 is ideal. It says that its for use on
Citroen,Fiat,LDV,Pergeot diesel engines. It fits the PRV like
it was made for it. Remove the starter motor and locate the tool
with a bolt through the lower mounting hole of the starter.
and put a nut on and tighten. The engine is then locked.
WWW.Laserhandtools.com

2. Use a high quality gas blow lamp I borrowed one with MAPP gas
this stuff burns very hot. Get the nut hot. Carefull not to
overheat the pulley.

It took Dean and myself on the Meter long bar and it just let go.
Thanks Dean.
Richard if you follow the above you should have a easier time.
Regards
Nick H





DOC UK Website: www.deloreans.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine **



Yahoo! Groups Sponsor
ADVERTISEMENT
click here


Yahoo! Groups Links



Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated