[doc] re still doesn't idle ok

["blackaddertoo" <blackaddertoo@xxxxxxxxxxx>]

Hi all

an update on my idle problems
idle ecu and idle motor checked and working by martin at DMUK.
now removed motor, blocked pipes and adjusted screws...car idle ok 
at 1500 rpm.
checked power to ecu ok at plug, checked switch ok at engine but 
diode reads no resistance either polarity. (should it?) n moved for 
further testing.
checked ground connection at ecu - Ok.
put Eecu and motor back in, shorted the diode/microswitch input to 
earth...car idle 30 second then dies. exactly the same problem.
removed diode short...idle 30 secs then dies.

so i am left to check the input from the distributor (should the car 
idle if this is dead and hence the ecu does not know engine speed??)
and if the leads from the ecu to motor are OK.

if i put a test light on the connector at engine end and switch 
ignition, should there be a short positive signal on the one (to 
either close the motor or open?)

then remove the microswith...do the same and the other lead should 
go positive.

that is correct is it not, middle lead to motor is ground and the 
other run motor positive one way and positive the other to close the 
air valve??.

Thanx for reading this!! and sorry to bore you. i am determined to 
resolve this (and enjoy it really!!)









DOC UK Website: www.deloreans.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine **

SPONSORED LINKS

Recreation	Automotive	Sports
Delorean part	Delorean cadillac

---

YAHOO! GROUPS LINKS

•  Visit your group "doc-uk" on the web.
   
•  To unsubscribe from this group, send an email to:
   doc-uk-unsubscribe@xxxxxxxxxxxxxxx
   
•  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

---