Re: [doc] re idle problems

["blackaddertoo" <blackaddertoo@xxxxxxxxxxx>]

Hi Martin

thanx anyway, if they are Ok could you recorded post back and i will 
payapl your fee over.
at least i can eliminate them as the problem.

i need to check the ecu is getting the correct pulses perhaps, is 
powering up ok etc.
can a test meter or light be put on the motor leads when running. i 
assume the power to the motor is pulsed as it is a stepper motor 
isn't it, with a sensor telling the euc where it is? (open or shut).
perhaps i need to give the co adusting screw half a turn left or 
right to see if that helps.

as i said, the injector squirt with light pressure from the air 
intake plate, so i thought no problems there, the spray pattern 
looked healthy.

i will check the leads as these are the one thing i did not do.

what should they read on a test meter?. and i will check the fire 
sequence. i have some of the neon flashers to try aswell.

regards

steve



--- In doc-uk@xxxxxxxxxxxxxxx, Martin Gutkowski <martin@xxxx> wrote:
>
> Bad news I'm afraid - both checked out fine. I fitted both to 
my "Tinny" 
> and it behaved perfectly. Including hunting when rich, revving on 
> startup etc. Goign to run a cld start test in the morning but it's 
not 
> looking likely there's problem.
> 
> Martin
> DMC Ltd
> 
> blackaddertoo wrote:
> 
> >hi Martin
> >
> >just wondered if you had had any luck.
> >
> >i know it sounds funny, but i'm hoping the idle motor is iffy, as 
i'm 
> >running out of options.
> >
> >Regards
> >
> >Steve
> >
> >doc 370
> >vin 1621
> >
> >
> >  
> >
>









DOC UK Website: www.deloreans.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine **

---

YAHOO! GROUPS LINKS

•  Visit your group "doc-uk" on the web.
   
•  To unsubscribe from this group, send an email to:
   doc-uk-unsubscribe@xxxxxxxxxxxxxxx
   
•  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

---