[doc] Re: re y pipe installation

["andrew986186" <andy@xxxxxxxxxxxxxx>]

if it had a copper washer, then it will need one, remember its a 
coolant pipe and will also get under pressure, your new thermistor 
should of had one on

stiff

--- In doc-uk@xxxxxxxxxxxxxxx, "blackaddertoo" <blackaddertoo@xxxx> 
wrote:
>
> Hi all
> 
> so finally getting the engine back together.
> 
> 2 broken spark plugs-thankfully just the ceramic. (hoovered 
through 
> a small pipe attachment the spark plug inlet-don't think it has 
but 
> if a fragment dropped in would it get pushed out the chamber with 
> the exhaust gasses?)
> 
> now should any sensors in the y pipe have copper washers.
> i assume the vac sensor self seals, but one of the existing others 
> has a copper washer.
> 
> the new replacement (i think thermister) does not have one with it.
> 
> do i use a new copper washer? or should non of these in the y pipe 
> have one?.
> 
> thanx for any help.
> 
> Regards
> 
> Steve
> doc 370
> vin 1621
>









DOC UK Website: www.deloreans.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine **

---

YAHOO! GROUPS LINKS

•  Visit your group "doc-uk" on the web.
   
•  To unsubscribe from this group, send an email to:
   doc-uk-unsubscribe@xxxxxxxxxxxxxxx
   
•  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

---