 
Re: [doc] finally driven her!!
    
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [doc] finally driven her!!
- From: "blackaddertoo" <blackaddertoo@xxxxxxxxxxx>
- Date: Mon, 01 Aug 2005 00:18:16 -0000
Hi thanks for the advice
i'll start perhaps with the 02 sensor as its an easy one to do.
i'm not looking forward to the plugs etc, looks a long job! and 
expensive as while you are there you might as well replace leads, 
cap, rotor, water pump pipes etc.
by the way i have a small leak coming from behind the water pump, i 
assume its the weak hose to the pump needs sorting, i understand a 
common problem.
the T panel just won't budge, seems the the foam under is sticking 
to the panel, may try a hairdryer to heat the panel carefully.
regards
Steve
--- In doc-uk@xxxxxxxxxxxxxxx, tny1964@xxxx wrote:
> mine was the same, after i replaced the injectors! a new set i got 
with my  
> car. turns out the previous owner had sodded about with the 
adjusting screws on 
>  the throttle assy,and the throttle  wasn't  shutting properly  
after i 
> sorted that it seems ok. but that was after replacing the cpr. you 
just  have to 
> check for air leaks just try to eliminate everything cheers  tony
> 
> 
> [Non-text portions of this message have been removed]
DOC UK Website: www.deloreans.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine **
    
  
  
    SPONSORED LINKS
  
       
  
  
  
  YAHOO! GROUPS LINKS
  
 Back to the Home of PROJECT VIXEN
 Back to the Home of PROJECT VIXEN