Fw: [DML]Front section Frame PICTURE

["Chris Parnham" <chrisparnham@xxxx>]

Keep a good eye under your cars!!! It starts me thinking again about
Stainless Steel or Hot dipped galvanising.


Chris P

----- Original Message -----
From: <jus4sho@xxxx>
To: <dmcnews@xxxxxxxxxxxxxxx>
Sent: Friday, February 16, 2001 3:03 AM
Subject: Re: [DML]Front section Frame PICTURE


> David, it looks like you ran into about the same thing I did on 02650. I
had
> to drill out the spot welds to remove the rotted section. I'm going to
clean
> the inside of the frame and recoat it before I weld in a new piece of
sheet
> metal. FYI, the bad corrosion in that area is the result of a combination
of
> things: 1) As you mentioned, there's no drain hole and 2) The epoxy barely
> made it into this section, leaving about half the metal inside this area
> completely bare. (Once I removed the lower plate, I could see how the
epoxy
> must have came in the little hole at the top, and barely made it halfway
down
> the sides before tapering to a paper-thin edge.)
>
> You can see the shots of the frame cut open on my site:
> http://www.angelfire.com/md2/projectdelorean/fr0101.html
>
> Steve
> VIN 2650 ("Project Delorean")
>
>
> Before posting messages or replies, see the posting policy rules at:
> www.dmcnews.com/Admin/rules.html
>
> To address comments privately to the moderating team, please address:
> moderator@xxxx
>