Re: [DML] Re: Wont start cold
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [DML] Re: Wont start cold
- From: stefan diklich <stefandmc@xxxxxxxx>
- Date: Sun, 23 Apr 2006 21:51:29 -0400 (EDT)
I have to double check the cold start injector, but the starter solenoid was replaced. I will also have to get someone to press down the air intake as well. But today it started fine, I dont know why and what caused it to not start yesterday. But im going to try and find out why. I believe, by the responses i have recieved, that it is an electrical problem. I am going to attempt to go over the electrical system, and possible replace the battery.
Are there any important grounds/ wires to check. I know the car fairly well, but electrical stuff is just not my cup of tea. Thanks and im sure this wont be the last time it will happen.
Nathan Sobieralski <valleyrat12@xxxxxxxxx> wrote: Have you physically checked to see that fuel is spraying from the
cold start injector? Replacing the thermo time switch will not
automatically fix the problem; it could also be your starter
solenoid.
Nathan
2277
--- In dmcnews@xxxxxxxxxxxxxxx, "stefandmc" wrote:
>
> Hey guys,
> Today I tried starting the car and it wouldnt start cold. This was
> after leaving it sitting overnight in my garage where I store it
> everyday. IT sat overnight so it is completly cold. It always
starts
> cold, somedays it just takes a few seconds of cranking, other days
it
> doesnt. Today it just kept cranking and cranking.
> So here is what I checked. I checked the spray pattern of 4 out of
the
> 6 injectors that I could get too. They all sparyed the same, and
it
> seemed to spray in the correct pattern. Secondly its getting gas
> because of injectors working and I can smell it.
> I tried the method, where you switch the cold start(blue) and warm
up
> regulator(grey) connectors, and still no luck starting.
> Im stumped now, I have replaced so much and now this problem
happened.
> Here is what I replaced. Thermotimeswitch, Fuel distributor, cold
> start valve, did the plug, rotor and cap, and new spark plugs.
Plus
> all the orings when my water pump was done.
> So if you guys have any ideas what could be causing this im all
ears.
>
To address comments privately to the moderating team, please address:
moderators@xxxxxxxxxxx
For more info on the list, tech articles, cars for sale see www.dmcnews.com
To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews
Yahoo! Groups Links
---------------------------------
Enrich your life at Yahoo! Canada Finance
[Non-text portions of this message have been removed]
To address comments privately to the moderating team, please address:
moderators@xxxxxxxxxxx
For more info on the list, tech articles, cars for sale see www.dmcnews.com
To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/dmcnews/
<*> To unsubscribe from this group, send an email to:
dmcnews-unsubscribe@xxxxxxxxxxxxxxx
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
Back to the Home of PROJECT VIXEN