How difficult would it be to produced a small run of replacement LF fenders? I'd assume that there are some firms out there that could re-create a fender from a sample, or 3D model (perhaps using hydroforming). If necessary to reproduce by hand, could this work be economically done domestically? Overseas? Please note that manufacturing is not an area of my expertise. --- In dmcnews@xxxxxxxxxxxxxxx, mike.griese@xxxx wrote: > > The problem is, we don't need a couple hundred left front fenders. > > -- > Mike > > > -------------- Original message from Chris Murley <qumefox@xxxx>: -------------- > > > > I'm not really so sure about this. If the left front fender dies were > > made available again that part alone would probably be cost effective > > enough to reman a few hundred of them. Granted they would still be quite > > expensive, at least they wouldn't be so rare. The other panels, your > > right. They are available enough as it is on the NOS/used markets not to > > be worth the cost. > > > > > > -- > > > > Chris > > VIN# 03209 > > http://badger.brazi.net/index.pl/delorean > > > > [Non-text portions of this message have been removed] > To address comments privately to the moderating team, please address: moderators@xxxxxxxxxxx For more info on the list, tech articles, cars for sale see www.dmcnews.com To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/dmcnews/ <*> To unsubscribe from this group, send an email to: dmcnews-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/