[DML] Re: Oil pressure switch removal and proper tool (my mistake)

["ksgrimsr" <knut.s.grimsrud@xxxxxxxxx>]

I had some folks drop me a note on the side pointing out my mistaken 
assumption of 23mm being an oddball tool size. With the size not being 
in my combination tool kits (either sockets or wrenches) and the local 
NAPA not carrying it, I had mistakenly presumed it was something 
oddball. However, it is apparently not that unusual and it's listed at 
Sears as a run-o-the mill tool.

Sorry about my mistake in asking for a tool I can get at my local 
Sears (sheepish grin).

    Knut


--- In dmcnews@xxxxxxxxxxxxxxx, "ksgrimsr" <knut.s.grimsrud@xxxx> 
wrote:
<snip>
> 
> I'm a bit puzzled about the proper sized wrench for the sensor. 22mm 
> is too small, and 24mm is too loose (I'm not pulling on a loose 
> fitting wrench and rounding the fastener off). According to my 
> calipers, 23mm should be just right, but a 23mm wrench is not a 
> standard tool.






To address comments privately to the moderating team, please address:
moderators@xxxxxxxxxxx

For more info on the list, tech articles, cars for sale see www.dmcnews.com

To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/dmcnews/

<*> To unsubscribe from this group, send an email to:
    dmcnews-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/