RE: [DML] Need some info!
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [DML] Need some info!
- From: mike.griese@xxxxxxxxxxxxxxxx
- Date: Wed, 22 Jun 2005 16:01:02 +0000
When you are cranking, make sure the throttle is completely open.
Test should be run with engine at operating temperature.
--
Mike
-------------- Original message from "Joseph Kuchan" <josephkuchan@xxxxxxxxxxx>: --------------
> >The base timing?
> 13 degrees BTDC
>
> >Radiator cap pressure?
> 15 lbs
>
> >How do you evaluate the condition of the engine using a compression
> >test?
> You can find this all over the internet, but basically:
> - Remove all spark plugs
> - make sure battery is well charged
> - connect compression tester to any cylinder
> - disable fuel pump (pull up plunger of iniertia switch
> - disconnect HT wire from tower of ignition coil. GROUND the output of the
> coil with another wire!
> - crank motor. watch gauge. record readings on 1st and 4th puffs. write
> down the numbers
> - repeat on all other cylinders
> - refer to any of the readily available engine diagnosis web pages for how
> to interpret results.
> - if a cylinder is low, add a couple of teaspoons of oil to it. crank over
> motor a few times to distribute oil. reconnect compression tester
> - repeat test (This is called a "wet" test and helps determine if your
> rings are bad.)
> >How to disable the ignition system?
> - As above: disconnect HT wire from tower of ignition coil. GROUND the
> output of the coil with another wire! Alternative: Disconnect the primary
> wiring to the coil.
> >How to disable the fuel delivery system?
> - pull the fuse on the fuel pump
>
> -Joe Kuchan
[Non-text portions of this message have been removed]
To address comments privately to the moderating team, please address:
moderators@xxxxxxxxxxx
For more info on the list, tech articles, cars for sale see www.dmcnews.com
To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/dmcnews/
<*> To unsubscribe from this group, send an email to:
dmcnews-unsubscribe@xxxxxxxxxxxxxxx
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
Back to the Home of PROJECT VIXEN