[DML] Cruise control question

[Ryan Wright <ryanpwright@xxxxxxxxx>]

So, I installed an Audiovox CCS100 cruise control in my car with the
magnet kit. However, it isn't locking in the speed, I believe due to
an issue with the magnets. The installation said to install 2 magnets
for a front wheel drive car, and 1 for a rear wheel drive. I installed
2 since this is "technically" a FWD setup. Was this correct?

I ran it in "Tach only" mode without the magnet kit and it worked
fine, with the exception that it wouldn't lock in below ~3000rpm (@
8000ppm setting). So I put it back to 2000ppm & tach/VSS and stuck the
magnet kit on, but no go...  I'm wondering if I didn't get the pickup
close enough to the magnets.

Any ideas would be appreciated.

-- 
-Ryan





To address comments privately to the moderating team, please address:
moderators@xxxxxxxxxxx

For more info on the list, tech articles, cars for sale see www.dmcnews.com

To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/dmcnews/

<*> To unsubscribe from this group, send an email to:
    dmcnews-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/