Re: Hub nut size
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Hub nut size



Angle drive is removed from the rear. Takes a 1.25" or 32mm open end
wrench. Will be torque'd pretty tight (I used a hydraulic floor jack
to lift the wrench). Turn the wheel to the left for better access.
Remember that this nut holds the spindle to the knuckle -- do not try
to move the car without it. The angle drive can be separated from the
nut if you want to use the car during repairs (I sealed the open hole
to keep trash out of my spindle. Made an 800 mile trip like that no
problem). Angle drive is held to the nut with a internal lock ring.

See Message #38247 for my repair experience.

Good luck.

Bill Robertson
#5939

>--- In dmcnews@xxxxxxxxxxxxxxx, "Kramer" <jettaman95@xxxx> wrote:
> Dear List,
> I need to know the socket size for the hub nut. I need to remove it 
> so that I can get out my angle drive to try and fix it. 
> Thanks again,
> Kramer
> ~10610






Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated