Fwd: [DML] Rack & Pinion determination

[george caprita <dobedoc2000@xxxx>]

Try P.J.GRADY,he has or had them in stock [has them special made], before you 
order them do this: mic o.d. of pinion shaft top & bottom,compare bearing cone i.d.to shaft o.d. this is what i found on a"rebuilt rack"i got:top shaft,.025 to.030 taper & wear, bottom shaft also worn,but not as bad,balls in both bearings all the same size.shaft was turning,bearings were not!! I called p.j.grady and he took the time to bale me out, even though i did't git the rack from him! he is a super,super nice guy to deal with,thanks P.J. hope this helps,George
Note: forwarded message attached.








---------------------------------
Do you Yahoo!?
Protect your identity with Yahoo! Mail AddressGuard

[Non-text portions of this message have been removed]