Re: Replacing the solenoids?
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Replacing the solenoids?



You need a good multi-meter to measure this. The solenoids should be
close to .25 ohms and they should be identical. You can measure this
up at the bulkhead connector in the round end. The green/yellow wire
is the common, so measure from it to either the blue wire or the brown
wire. It will be more accurate if you disconnect them first by
removing the brass hex nuts. Be careful not to loose the tiny split
ring washers.
David Teitelbaum
vin 10757



--- In dmcnews@xxxxxxxxxxxxxxx, "Harold McElraft" <hmcelraft@xxxx> wrote:
> If they work they are most likely ok. You can test the resistence 
> against a new one to confirm condition. They are not a known for a 
> high failure rate. 
> 
> Harold McElraft - 3354
> 







Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated