Re: [DML] Torque values and spark gaps

[id <ionicdesign@xxxx>]

If they are the fuel lines to the fuel dist you need torque specs for dont bother,
tighten them down with new copper washers so they are snug and then give them about 1/2
turn and check for leaks and if you see them leaking snug it down a little more. I found
in the manual some where it was like 13 or 14 lbs of torque for the fuel line to dist
bolts, i tried this and almost snapped one of the botls off in my fuel dist it should be
more like 3 to 5 lbs.

Mark
6683

jordan rubin wrote:

> what i really needed was that values for the fuel
> distributor.
>
> jordan 11613
> --- John Hervey <john@xxxx> wrote:
> > Be carefull even on the torque values. You might
> > find thats to much. Use a
> > 3/8" drive and snug the plugs down and then give it
> > a little lock down.
> > Usually that's enough. Threads could be striped if
> > to much torque.
> > John Hervey
>