Re: Torque question

["Harold McElraft" <hmcelraft@xxxx>]

I don't believe it is specifically listed in the manual. However, I 
used the M10 bolt spec of 11 lb/ft or 15 Nm. I also put the torque 
to the nuts again about 15 min later because it looked to me like 
the gasket would compress some. I got a bit more movement to the 
torque wrench click. So far so good at about 8,000 miles on the job.

Harold McElraft - 3354

--- In dmcnews@xxxxxxxxxxxxxxx, Travis Goodwin <tgoodwin@xxxx> wrote:
> The process for removing the exhaust manifold has begun. Tuesday I 
began
> spraying all the bolts with penetrating oil and will be doing it 
every night
> until I actually get time to take them off.
> 
> My question is this:
> 
> What are the torque settings for the exhaust manifold?