Did you use magnet kit for Audiovox cruise unit? If so, how did you mount stationary pickup unit? STILL haven't installed mine, but hope to before next trip up I-95. Am considering making custom triangular bracket to mount pickup on passenger side of transmisson using tapped holes already there. Bill Robertson #5939 >--- In dmcnews@xxxxxxxxxxxxxxx, "miltdanfoss" <dan.foss@xxxx> wrote: > Good news! > > Fixed my blown water pump, and after I found that my poor job of > torqueing the crankshaft pulley nut resulted in a 100% loose nut, and > a loose pulley, I have all back together. > > Oh yeah, while it was out I installed a Audiovox CCS-100 cruise > control, which fit nicely in the spot for the digital clock and I was > able to install it with minimal modification (only hole I had to > drill in my D was in the engine electrical compartment. I modified > the wiring to the "A/C Panel Illumination" relay at the same time, > and most of the wiring I needed for the cruise was found there. I > picked up the extra post on the dimmer thermistor in the center > console for the other I needed. > > Dan in Cocoa (3932)