In a message dated 1/30/03 8:39:05 AM Central Standard Time, darkstarmedia@xxxx writes: > Also, after i re installed my dash i noticed that my temp gauge doesn't > work. it just points straight down... any ideas?? > > Darkstar hello, gauge problems are often caused by the tabs on the PCB board being bent and touching each other. remove the binnacle again, and remove the two connectors. check the tabs and make sure they are straight, then reinstall. that will probably do the job. Andy Soma576@xxxx 1982 DeLorean DMC-12 VIN#11596 Fargo, ND 58102 [Non-text portions of this message have been removed]