Re: [DML] engine stamping pits can you fill them?
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [DML] engine stamping pits can you fill them?



In a message dated 11/21/02 7:22:06 AM Central Standard Time, 
hecklerkochgmbh@xxxx writes:


> was wondering if anyone out there has found a way to safely fill them in?If 
> not is there at least some kind of fix anyone would suggest?If you are not 
> sure what Im asking about its the deep little square pits on top of the prv 
> between the heads.They always get filed with dirt and moisture which could 
> cause them to corrode through.I would like to fill them in with something 
> but dont kow if its such a good idea since this might allow some moisture 
> to be trapped in there,exactly what i dont want! 


I would say that if they are there - they are there for a reason! don't fill 
them, i think they act as a heatsink. if you remove the intake manifold and 
waterpipes (which i assume you have done) just clean them out with a 
screwdriver and a shopvac, maybe some compressed air and you should be on 
your way for another 20 years......... that's what i did and i'm not going 
to lose any sleep over it because that's a lot more care than most of the D's 
out there have seen!

Andy

Soma576@xxxx
1982 DeLorean DMC-12 VIN#11596
Fargo, ND 58102


[Non-text portions of this message have been removed]






Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated