Hey All. My woes continue here in Toronto .. I am finally able to get the car running with no problem .. But she idles at 2000 and is HOT I have tried many things : -Adjusting the richness .. Enriching and Leaning the mixture .. Does not help .. -Adjusting the timing . 13 degrees before TDC on the pulley on the first marking 105 degrees , and then the rotor on the distributor rests at the notch after its stabbed in -an altogether alternate mixture control unit and throttle body from another DeLorean I have learned . that when I run the car and disconnect the Oxygen sensor .. it will idle around 1500 rpm I hooked it up to a dyno.. and the readings from the exhaust when its enriched are at 16.30 dilution, then at 12.90 when leaned out But in both cases the engine is HOT . we measured the temp in both cases and in both cases the cat ranges from 500 - 800 degress faherhiet When I reconnect the O2 sensor .. it idles high again and will run at 700 degrees Could it possibly be a computer problem? Is there something else I can try? I am going nuts here .. all your help is GREATLY appreciated as always You can reply to me directly at ken@xxxx Thanks again Kenneth 05541 - with a fever [Non-text portions of this message have been removed]