Re: [DML] foam gasket on blower

[jwit6@xxxx]

In a message dated 5/13/02 10:38:32 PM Eastern Daylight Time, 
dmc4687@xxxx writes:

<< It works fine... maybe a little less air pressure. why?
>>
Probably the foam seals on the back of the heater/air box housing under the 
pass side dash. Mine did the same thing. Look for them to be missing or not 
properly sealed. You can't see them but you can feel the escaping air from 
the blower and the out of place/loose gasket if you feel up there with your 
hand.

Run the blower and start looking for air escaping from anything other than 
one of the actual vents.
Jim 6147