RE: [DML] Help: How do I fix my trunk latch?
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [DML] Help: How do I fix my trunk latch?



Perhaps epoxy is the solution. You can buy five minute epoxy at Wal-Mart or
Home Depot type stores.
Remove the Hood, engine cover and fill the hole with epoxy from the top
side. Over fill slightly and use a toothpick to work out any air bubbles.
How about putting a nut on the end of the eye hook and epoxy that into the
cover. Let it fully cure, perhaps a day or longer so it develops its full
strength.

-----Original Message-----
From: dmc83_gullwing [mailto:jasperkins@xxxx]
Sent: Friday, February 22, 2002 3:13 PM
To: dmcnews@xxxxxxxxxxxxxxx
Subject: [DML] Help: How do I fix my trunk latch?


I noticed the other day that my Trunk (engine cover) loop latch had
fallen off, and was stuck in the release mechanism. After getting
my wife to pull the trunk release, I was able to remove that eye
hook from the release mechanism.

I need a good work-around to keep that eye hook in the hole. Any
recommendations?

Thanks!







Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated