Re: Re: [DML] Re: Idle Speed thermistor

[shain@xxxx]

Hello,

I noticed that the location is under the air intake. Is there a way to gain access to it without removing the whole intake? Or is there a wire lead that i would be able to gain access to?

- Shain
#10140

----- In Response To -----

> Shain, Eric and group, The thermistor starts off at about 10,000
> ohms cold. It's 41Degrees this morning, so in my storage containers,
> that was the start. If you just hold it in you hand while taking a
> reading, the ohmage will drop. Be sure to use a good digital VOM,
> some of the older and cheaper analog meters may load the circuit
> to much. Measure right across the terminals.
> John
> http://www.specialtauto.com/