water pump/ advice
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

water pump/ advice



I recently found that my machine had totally run out of water/coolant....
I filled up the water to full (a few times, as each time I started the
machine up the level went down again). Then I put it on level ground and
opened the bleeder valve to get the remaining air out... Nothing came
out. I'm a little perplexed, becuase I did a bleeding a few months ago
and everything seemed to be working fine at that time. 

Can I assume that my water pump is not circulating water??? The pulley
is definitely TURNING on the outside, at least. What else might cause
this lack of bleeding problem? I'd figure that it'd bleed off extra
fluid when the overflow tank was full to the brim... is this not so?

Jim.
1537
________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today! For your FREE software, visit:
http://dl.www.juno.com/get/web/.





Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated