Re: [DML] Re: High RPM when hot

["chris" <chris@xxxx>]

I had high revs, about 2.5k, it turned out to be the connector going to the
idle speed thermal resistor. one of the pins had become dislodged and was
not making a connection. You need flexable hands to get under the intake
manafold and unclip it!

Chris Spratt
Vin 16327
----- Original Message -----
From: <DMCVegas@xxxx>
To: <dmcnews@xxxxxxxxxxxxxxx>
Sent: Wednesday, May 09, 2001 3:33 AM
Subject: [DML] Re: High RPM when hot


> If your cold start valve was open all the time, it would flood the
> engine untill it dies. It almost sounds as though your idle speed
> regulator is on the blink. When my idle speed circuit was down, I
> rigged everything up where I could set the idle manualy. When cold,
> the engine would idle about 800-900 RPM's. With the valve in the same
> position with the engine hot, the idle would jump to 1600 RPM's. If
> your idle is up around 3000 RPM's, then your idle speed motor is full
> open. 

> -Robert
> vin 6585