Re: Temp Sensor - how to test?
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Temp Sensor - how to test?



Before you go tearing things apart make sure the wire going to the 
sensor is still attached! The sensor is located on the front of the 
right cylinder head and the wire should be green/blue. If all of the 
other gauges are working it is unlikely the problem is in the dash. 
The temp sensor has a low failure rate so the most common thing is a 
wiring problem between the gauge and the sensor. It is very easy to 
knock things loose in the front of the motor because it is so tight to 
work in there. Refer to Wiring Diagram section 2-C+D. The gauge is 
#275 and the sensor is #183
David Teitelbaum
vin 10757


--- In dmcnews@xxxx, E Grauff <datamonk@xxxx> wrote:
> My temp gauge has stopped working. I'd like to see if it is the 
sensor or
> somewhere in the wiring. Does anyone know how to test the sensor? 
I
> looked through the manual, but all I saw was how to replace one . . 
. 
> Thanks
> Eric






Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated