Re: [DML] Engine Problems
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [DML] Engine Problems



When you opened the fuel distributor, did you remove the piston? If you
did, you may have put the piston back in upside down. Also, the needle and
seat on the side of the fuel distributor may have stuck. Give Steve Wynne,
DeLorean Joe or Rob Grady a call. They can tell you which way the piston is
supposed to go in. If you are not close to any of the DMC Service
centers,find a Bosch service center that can check all of the various fuel
pressures and make the proper adjustments to the system.

Scott Mueller
DOA/DMCNEWS
002981
----- Original Message -----
From: Andrei Cular <acular1@xxxx>
To: <dmcnews@xxxxxxxxxxx>
Sent: Wednesday, January 24, 2001 11:59 AM
Subject: [DML] Engine Problems


> Ok I have finally reached the point of fustration that I am going to ask
for
> help.
, and rebuilt the fuel distributor, even after everyone
> told me not to> My problem is that it would not accelerate. When I would
hit the gas it
> would just bogg down and eventually stall unless I pushed the air sensor
> plate down by hand. > The only part of the fuel system that I have not
replaced or cleaned out is
> the accumlator






Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated