door hinge shims

[Delorean17@xxxx]

Hello List,
I put a new door on my DMC last month and I am not able to open it 
because it hits the fiberglass t section(the roof under the t panel) The T- 
panel has been off my car because the door would bend the edge right off of 
it. I adjusted the 4 door mounting bolts to their full length and that is 
not even coming close to helping me. 

I need to add a verticle shim that goes in between the back of the hinge 
and the fiberglass piece. the height of the door looks good, just needs to 
be pulled outward a littel. I see that my drivers side door allready has a 
shim and it works perfect. My passenger side does not have a shim behind the 
hinge mount. I just got my torsion bar back on and it looks like it is 
coming off again. has anyone done this shim opperation before? I have read 
the manual but it is not super clear. Do I just release the torsion bar and 
losen the mounting bolts and tap a shim into place? and where can I get 
these? dmc joe, do you have them available?

Thanks list

David
#2496-Looking for passenger side rear fender,minor dings ok, no creases