[DML] Re: Mirror switch - Jumping Procedure
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[DML] Re: Mirror switch - Jumping Procedure



hello all/ i had the same problem with my switch. i was able to repair it
using all the parts that were inside//this can be done but is a tough
procedure?? good luck bob miller



-----Original Message-----
From: DMC Joe <dmcjoe@xxxx>
To: dmcnews@xxxxxxxxxxx <dmcnews@xxxxxxxxxxx>
Date: Sunday, March 19, 2000 7:13 AM
Subject: [DML] Re: Mirror switch - Jumping Procedure


>The mirror switch adjuster is non-serviceable as you have discovered. New
>switches are available from us and the other DeLorean part suppliers for
>$54.09.
>
>DMC Joe / De Lorean Services / <dmcjoe@xxxx>
>Web Site: <www.deloreanservices.com>
>.
>
>----- Original Message -----
>From: Jonathan Heslop <gatewayaag@xxxx>
>To: <dmcnews@xxxxxxxxxxx>
>Sent: Saturday, March 18, 2000 7:43 PM
>Subject: [DML] Mirror switch - Jumping Procedure
>
>
>> It all started with an inoperative switch...............
>>
>> The window switch worked fine on everything but the horizontal control
for
>> the right side. I popped the switch out and began to take it apart. BIG
>> MISTAKE!
>>
>> This is the most complex set of parts and wiring design I've ever seen
for
>> such a simple switch. The guy that desgined this must have been a mad
>mad!
>>
>> Springs, rods, ball bearings, etc went all over the work bench when I
>opened
>> this thing up. I gathered the parts, cleaned the contacts, and spent two
>> hours trying to get this thing back together. I took it out to the car
>and
>> hooked it up. It worked!! I pushed in into the hole and went to put the
>> knob back on. I pushed on the knob to secure it and that's when it
>> happened........POP! The back came off and those dozen little parts shot
>> into the door panel. I retrieved a good number of the parts after hours
>of
>> searching, but the rest are gone for good.
>>
>> Does anyone have a junk window selector switch or some of it's
>components??
>> I'm missing one of the BB's, a "bar bell" rod, and the bigger of the two
>> springs (used behind the BBs).
>>
>
>
>
>------------------------------------------------------------------------
>Before posting messages or replies, see the posting policy rules at:
>www.dmcnews.com/Admin/rules.html
>
>To address comments privately to the moderating team, please address:
>moderator@xxxx
>
>------------------------------------------------------------------------
>eGroups.com Home: http://www.egroups.com/group/dmcnews/
>http://www.egroups.com - Simplifying group communications
>
>





Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated