[DML] Re: Ignition Distributor
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[DML] Re: Ignition Distributor



There are two allen screws holding the fuel distributior/air fuel mixture
assembly down. They are on the top-rear of the intake. Remove these two
allen bolts and you can lift the fuel distributor up enough to easily get
the cap off.


Hope this helps,


Duke

----- Original Message -----
From: gwells <gwells@xxxx>
To: <dmcnews@xxxxxxxxxxx>
Sent: Thursday, December 30, 1999 2:51 PM
Subject: [DML] Ignition Distributor


> I need to remove the cap to the Ignition Distributor. The books say to
> remove the whole distributor you need to remove first the fuel
distribution
> unit. By the looks of it, the same applies if you only want to remove the
> cap. Is this correct, or is there some way in which the cap can be removed
> without removing anything else.
>
> G.H.Wells
> VIN 17152
>
>
> ------------------------------------------------------------------------
> Before posting messages or replies, see the posting policy rules at:
> www.dmcnews.com/Admin/rules.html
>
> To address comments privately to the moderating team, please address:
> moderator@xxxx
>
> ------------------------------------------------------------------------
>
> eGroups.com home: http://www.egroups.com/group/dmcnews
> http://www.egroups.com - Simplifying group communications
>
>
>
>





Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated