Cecil, Valeo made the change a while back. Take a look at the old VS the new on the site. Also the plastic inside was a good improvement. No more shaft binding or squeak as it moves back and fourth. John Hervey http://www.specialtauto.com/delorean-parts/clutch-transmission.html -----Original Message----- From: Cecil Longwisch [mailto:dmc1982@xxxxxxx] Sent: Wednesday, March 10, 2004 3:39 PM To: dmcnews@xxxxxxxxxxxxxxx Subject: [DML] cluth release bearing > I purchased a new cluth release bearing from a DeLorean supplier and when > comparing it to the old one they are not the same. The old one strongly > clips to the yoke while the new one has a tang on one side that sort of > clips and the other side is straight. The center hole guide is a plastic > type material on the old one and the new one is all metal. > My concerns are it does not seem to be attached as well to the yoke as the > old original one and the metal against metal is less desirable for the cener > hole. > > Has anyone else seen this and should this be of concern? > I actually considered using the old carrier for the the new bearing but it > has one of the ears broken off which is probably why it was making an > undesirable noise. > > Cecil Longwisch > #10663 To address comments privately to the moderating team, please address: moderators@xxxxxxxxxxx For more info on the list, tech articles, cars for sale see www.dmcnews.com To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/dmcnews/ <*> To unsubscribe from this group, send an email to: dmcnews-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/