 
[DML] Re: Engine runs rough after pop & smoke from engine bay
   
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[DML] Re: Engine runs rough after pop & smoke from engine bay
- From: "deepdmc" <deepdmc12@xxxxxxxxxx>
- Date: Fri, 19 Aug 2005 20:14:15 -0000
Thank you soooo much. The problem has been fixed. Apparently what 
happened was the engine backfired and the pressure pushed one of the 
fuel injectors out of the boot. I pushed the injector back in and 
secured the retaining clip and the rough idle completly went away. 
On a side note what would have caused the backfire in the first 
place? This is the first time it has ever backfired, I recently 
leaned the fuel adjustment because the engine started to surge at 
idle, but i only leaned it a very tiny amount. Once again thank you 
so much.
Justin Alivandi 16579
--- In dmcnews@xxxxxxxxxxxxxxx, "Harold McElraft" <hmcelraft@xxxx> 
wrote:
> If you had a backfire in the intake, pressure from the explosion 
> could have dislodged several items including the idle motor tube, 
> several vacuum lines, intake seals, etc. or even a fuel injector.
> 
> I would suspect vacuum lines first.
> 
> Harold McElraft - 3354
> 
> 
> --- In dmcnews@xxxxxxxxxxxxxxx, "deepdmc" <deepdmc12@xxxx> wrote:
> > OK here is what happened. Drove home from work and the car was 
> running 
> > fine. Went to drive the car about 40 minutes later. Turned the 
key 
> on 
> > for a few seconds to let the fuel pump do its thing, then went 
to 
> > crank it. The engine started right up as usual, but then as soon 
> as I 
> > let off the starter I heard a pop come from the engine bay. I 
> looked 
> > in the rear view mirror just in time to see a pretty hefty puff 
of 
> > smoke. It looked like it was coming from the drivers side of the 
> > engine bay towards the back of the bay near the light switch & 
> > resistor area. The car starts and seems to run fine. But now the 
> idle 
> > is really rough, it vibrates the whole car. My first assumption 
> was 
> > that the relay on the back wall had popped, I replaced it but it 
> still 
> > runs rough. Any one have any ideas? What should I check first?
> > 
> > Thanks,
> > 
> > Justin Alivandi
> > 16579
To address comments privately to the moderating team, please address:
moderators@xxxxxxxxxxx
For more info on the list, tech articles, cars for sale see www.dmcnews.com
To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews 
Yahoo! Groups Links
<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/dmcnews/
<*> To unsubscribe from this group, send an email to:
    dmcnews-unsubscribe@xxxxxxxxxxxxxxx
<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 
 Back to the Home of PROJECT VIXEN
 Back to the Home of PROJECT VIXEN