 
[DML] Re: AC went "POOF!"
   
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[DML] Re: AC went "POOF!"
- From: "Harold McElraft" <hmcelraft@xxxxxxx>
- Date: Tue, 24 May 2005 01:56:55 -0000
Bob
The OEM fans, when working properly, pull a lot of air that keeps 
the AC high pressure down. In the Texas heat that can be near 300 
psi on a full charge. The fans need to be working at their peak. The 
OEM or DMCH replacements are the only ones I have seen that move 
enough air for me.
Harold McElraft - 3354
--- In dmcnews@xxxxxxxxxxxxxxx, "Videobob Moseley" <videobob@xxxx> 
wrote:
> Thanks David, I appreciate the advice.
> I have actually gotten several informative and helpful emails from 
several 
> people
> that I think will be helpful.
> It sounds like this is going to be fairly expensive!
> I think I will replace everything that can be replaced if I need 
too.
> All of the stuff on my car is stock and I am wearing it out.
> Any car this age would be having these problems I guess.
> The Texas days are hitting over 100F and stressing the system out.
> 
> I have Hervey's replacement fans installed and I was the first to 
have them.
> They worked OK as a replacement but I feel that they are not as 
powerful
> as the originals.
> I am looking into installing some custom electronic fans I have 
seen some 
> hot-rod
> guys using that have some high air flow.
> Another issue I need to remedy is that when I re-installed my 
radiator after
> my wreck is that I did not re-install the shroud because I could 
not get it 
> to fit.
> Some of the brackets were bent, so I got it as close as I could 
and left it.
> I noticed that there was a significant heat build up in the trunk.
> One day after a drive my bare calf brushed up against the fender 
and it was
> so hot that it left a burn on my leg that took a week to heal!
> It get's really hot up front from the air blowing.
> 
> Now, when I mentioned some of my cooling problems to Hervey back 
when
> I installed the fans, he argued that the missing shroud could be 
the 
> problem.
> I do not totally disagree however that would only effect my moving 
> temperature.
> My idle temp was higher and that tells me I need more fans.
> Hervey says his new fans are pulling 80% of the original at half 
the juice.
> I would rather have 100% or greater and take advantage of that big 
> alternator
> that I bought from him.
> 
> I just hope I can get all of this done before the DMCH open house.
> Otherwise I will be driving the Dodge (with the AC blasting!)
> 
> Thanks to everyone who offered advice.
> - Videobob
> 
> >From: "David Teitelbaum" <jtrealty@xxxx>
> >Reply-To: dmcnews@xxxxxxxxxxxxxxx
> >To: dmcnews@xxxxxxxxxxxxxxx
> >Subject: [DML] Re: AC went "POOF!"
> >Date: Mon, 23 May 2005 01:03:42 -0000
> >
> >You blew a hose or a seal. The most likely thing is the discharge 
hose
> >that goes from the compressor to the condensor core. You will 
have to
> >go to an A/C shop and they will pressure test it to find the leak.
> >After repairing the leak (whatever it is) they should replace the
> >dryer/accumulater, the orifice tube, and the service valves. The 
oil
> >level should be measured and changed. The system should again be
> >pressure tested with a "sweep charge", evacuated to a hard vacuum 
for
> >at least 1/2 hour and then refilled with R-12. It should be 
tested for
> >performance and the low pressure switch adjusted. As you can see, 
this
> >is not for a "garage mechanic" as it is unlikely you would have 
the
> >proper tools. If you cannot get R-12 get another "Drop-In" 
replacement
> >like R-414a. Do not let the shop talk you into R-134.
> >David Teitelbaum
> >vin 10757
> >
> >
> >
> >--- In dmcnews@xxxxxxxxxxxxxxx, "Robert Moseley" <videobob@xxxx> 
wrote:
> > > I was driving my car to a local car show yesterday,
> > > I hadn't driven it for about a week,
> > >
> >
> >
> >
> >
> >
> >
> >To address comments privately to the moderating team, please 
address:
> >moderators@xxxx
> >
> >For more info on the list, tech articles, cars for sale see 
www.dmcnews.com
> >
> >To search the archives or view files, log in at 
> >http://groups.yahoo.com/group/dmcnews
> >Yahoo! Groups Links
> >
> >
> >
> >
> >
> >
To address comments privately to the moderating team, please address:
moderators@xxxxxxxxxxx
For more info on the list, tech articles, cars for sale see www.dmcnews.com
To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews 
Yahoo! Groups Links
<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/dmcnews/
<*> To unsubscribe from this group, send an email to:
    dmcnews-unsubscribe@xxxxxxxxxxxxxxx
<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 
 Back to the Home of PROJECT VIXEN
 Back to the Home of PROJECT VIXEN